Idiomas disponibles
Idiomas disponibles
- Check the condition of the contact pins and the rings.
- Use dry, compressed air to clean.
1
Remove the retaining nut, the nozzle, and the contact tip.
2
Using the spiral guide, cut the cable near the diff user. Remove the guide and
cut the number of threads equivalent to the size of the contact tip thread, leaving
up to 5 mm extra for tightening.
3
Make a chamfer on the end point of the liner, in order to fi t the liner into the
contact tip. Use a tool to leave the internal diameter at a slight angle.
4
Put the liner and contact tip back into the torch, tightening as necessary
5
Place the liner nut back in the line, tightening as necessary.
To demonstrate the exchange of the liner
in video access through the qr code:
Pt
Pt
En
For torches with extraction system: Perform internal cleaning periodically.
Clean the inside of the handle with a brush. Use a cleaning agent such as
Es
an industrial, water-based detergent. Replace the fl exible hose if necessary.
- The liner must be cleaned with dry,
compressed air. It must be replaced when
deformed, rusty, liner or if there is a break
in the wire passage occurs. The cable must
be fully stretched in order to remove it from
the torch. Replace the cable according to the
following steps:
Protect the environment by recycling consumables.
12
