Idiomas disponibles
Idiomas disponibles
,
CONNECT
THE TUBING
TO THE
REFRIGERATOR
Removing and Replacing Valve Cover
NOTE:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
1. Remove the plastic flexible cap from the water
valve.
IO.TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
Reattach the compressor compartment access cover.
2. Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
3. Insert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the fitting.
& CAUTION: Check to see if leaks occurs at water
line connections.
Tubing C_
1/4'mpression_
Nut _
Ferrule _
'e
(sleeve)
_k_
\
Refrigerator
Connection
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the wall.
Push the refrigerator back to the wall.
12. START THE ICEMAKER
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below. It
will then begin operation automatically
if the icemaker
power switch is in the I (on) position.
33
