Idiomas disponibles
Idiomas disponibles
USER INTERFACE FEATURES
Your Bixpy PP-768 Control Module has a number of smart features to help communicate various functions.
The chart below outlines the various user interface features of your battery.
EVENT
Kill switch engaged
Kill switch removed
Charger plugged in
Battery fully charged
Warp Speed
Quad Click Start
Low battery
indication
LED LIGHTS
Turn on to indicate charge level
LEDs turn off after ~5 seconds
If motor is running it will immediately stop
LED on Charger red when battery taking
charge
Battery LEDs flash to indicate charging
function. LEDs fill-in as battery charges
until battery fully charged
LED light on charger turns from Red to
Green and stays green
Battery LEDs remain on and all 6 are
solid, indicating a full battery
LEDs on while kill switch engaged
indicating battery level
LEDs turn on in sequence of 2 lights as
you click the kill switch until motor starts
running on the fourth click
Last LED blinking to indicate
BEEPER
FUNCTION
A double beep to
Battery turned on and
indicate engagement
ready
One beep to indicate
Battery turned off and
battery turning off
in deep sleep
One beep on plug
Battery taking charge
mating and unmating
indicated by LED lights
No beep
Battery is fully charged.
Remove charger from
battery
A double beep just
Motor engages at full
prior to motor ramping
speed using the Double
up to speed 12
Click Warp Speed
function
Beeper sounds one
Battery will supply the
beep on engagement,
motor with 50% power
no beep through the
for emergency
process and one last
operation
long beep before the
motor begins to run at
50% power
No beep
The last LED will
continue to blink as you
use up the last of your
battery's power
Page 12
