Idiomas disponibles
Idiomas disponibles
CHARGING YOUR BIXPY PP-768
Your PP-768 Battery ships with a 7.0 amp charger that will charge the battery in roughly 5 hours.
Plug your charger into the charging port of your battery to start the charging process. You do not need the
kill switch to be engaged.
Your charger has an LED indicator light that turns green once it's plugged into the wall. The green LED light
will turn red when the charger is charging your battery.
Your 6 white LED lights will also start flashing to indicate that the charging cycle is active.
Once your battery is full, all 6 white LEDs will stay on until you remove the charger. The red LED on your
charger will turn green and stay green permanently.
● NEVER use another charger to charge your Bixpy batteries
● NEVER charge your batteries unattended
● NEVER leave the charger on after the battery has been charged
● Lithium batteries do not trickle charge
● Do not charge the battery in a wet environment
● Your charger is NOT waterproof
● Monitor your battery and maintain a charge even when not in
use to prevent over-drainage
● Store between 0°C to 55°C (32°F to 131°F)
● Operate between -20°C to 60°C (-4°F to 140°F)
● Always wear your kill switch!!
● DO NOT open battery core, it may cause a fire or explosion
● Lithium batteries CANNOT be connected in parallel like
conventional batteries. Doing so WILL result in a fire and/or
explosion
● Tampering opening of the case or modification to the batteries
will void your warranty and may cause fires/explosions
● Do not power other devices or motors using Bixpy batteries
● Do not keep Outboard Power Pack under direct sunlight or in a
parked vehicle for extended periods
● Always use provided connector caps when connectors are not
mated
Page 9
