Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3 Position the crown molding so that the lower surface (A in Fig. 37) contacts the fence
as in Fig. 46.
Head
Bevel angle scale
4
Miter angle scale
Turntable
Fence
B
Table on base
Cutting method of crown molding without tilting the saw blade
Crown molding vise ass'y
(optional accessories)
6mm knob
bolt
6mm knob bolt
Crown molding stopper (L)
6mm wing bolt
(Optional accessories)
Fig. 47-a
(2) The crown molding vise (B) (Optional accessory) can be mounted on either the left
fence (Fence (B)) or the right fence (Fence (A)). It can unite with the slope of the
crown molding and vice can be pressed down.
Then turn the upper knob, as necessary, to securely attach the crown molding in
position. To raise or lower the vise assembly, first loosen the 6mm knob bolt.
1
Fence (A)
Base
Fig. 43
A
Fig. 45
Crown molding stopper (R)
(optional accessories)
Head
Bevel angle scale
3
Fence (B)
Base
Fence
A
(1) Crown molding Stopper (L) and (R)
(optional accessories) allow easier cuts of
crown molding without tilting the saw
blade. Install them in the base both-sides
side to be shown in Fig. 47-a. After
inserting Tighten the 6mm knob bolts to
secure the crown molding Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include
Crown molding Stopper (L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
English
2
Miter angle scale
Turntable
Fig. 44
B
Table on base
Fig. 46
35
Tabla de contenido
