Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
8 mm bolt (B)
(Stopper for right 45° bevel angle)
Fig. 12-a
7. Securing the workpiece
WARNING:
8. Installing the holders ... (Optional accessory)
6 mm knob bolt
(Optional accessory)
Steel
square
Holder
(Optional
accessory)
6 mm wing nut
(Optional
accessory)
9. Stopper for precision cutting ... (Stopper and holder are optional accessory)
Stopper
(Optional accessory)
Workpiece
6 mm knob bolt
(Optional accessory)
Fig. 14
20
Indicator
(For left bevel
scale)
8 mm set screw
(Stopper for 0°
not shown)
Always clamp or vise to secure the workpiece to the fence; otherwise
the workpiece might be thrust from the table and cause bodily harm.
Base surface
Height adjustment bolt 6 mm
(Optional accessory)
Fig. 13
Holder
(Optional
accessory)
Move
Indicator
(For right
bevel scale)
8 mm bolt (A)
(Stopper for left 45° bevel angle)
The holders help keep longer workpieces
stable and in place during the cutting
operation.
(1) As indicated in Fig. 13, use a steel square
for aligning the upper edge of the holders
with the base surface.
Loosen the 6 mm wing nut. Turn a height
adjustment bolt 6 mm, and adjust the
height of the holder.
(2) After adjustment, firmly tighten the 6 mm
wing nut and fasten the holder with the
6 mm knob bolt (optional accessory). If
the length of Height Adjustment Bolt 6
mm is insufficient, spread a thin plate
beneath. Make sure the end of Height
Adjustment Bolt 6 mm does not protrude
from the holder.
The stopper facilitates continuous precision
cutting in lengths of 11-7/32" to 17-3/4" (285
mm to 450 mm).
To install the stopper, attach it to the holder
with the 6 mm knob bolt as shown in Fig.
14.
Set pin (A)
Pull
Fig. 12-b
Tabla de contenido
