Scheppach TIGER 2500 Traducción Del Manual De Instrucción Original página 25

b) The permissible rotational speed for tool at-
tachments must be at least as high as the max-
imum speed cited on the electric tool. Accesso-
ries that rotate faster than permitted can break and
fly off at high speed.
c) Never grind on the side surfaces of the grind-
ing disc. Grinding on the side surfaces can cause
the grinding disc to break and fall apart.
Residual risks
m The machine has been built according to the state-
of-the-art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Danger of injury for fingers and hands due to the ro-
tating grinding disc.
• Hazard due to electrical power with the use of im-
proper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety in-
structions" and "Intended use" are observed along
with the complete operating instructions.
7. Technical data
Dimensions L x W x H
Tool rest ø
Grindstone
Grindstone idle speed
Cutting speed
Weight approx.
Motor
Power
Motor speed
Operating mode
Technical changes reserved!
Noise
Total noise values determined in accordance with
EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
320 x 325 x 335 mm
12 mm
ø 250/12 x 50 mm
90 min
-1
1.2 m/s
16 kg
230 – 240 V~ / 50 Hz
200 W
1400 min
-1
S1 100%
71.7 dB
3 dB
82.7 dB
3 dB
www.scheppach.com
8. Before commissioning
• Open the packaging and carefully remove the device.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the end of the
warranty period.
ATTENTION!
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
Before connecting the machine to the mains power,
make certain that the data on the type plate matches
with the mains power data.
m Warning!
Always ensure that the machine is switched off and dis-
connected from the power supply before changing the
device settings.
• All covers and safety devices must be properly fitted
before switching on the device.
• The grindstone must be able to run freely.
• Before operating the on/off switch, make sure that
the grindstone and honing wheel are correctly
mounted and that the moving parts of the device
function smoothly. Visually inspect both for defects.
• Replace a damaged or worn grindstone.
9. Installation instructions
m Attention!
Always make sure the device is fully assembled
before commissioning!
9.1 Installation and setting
Please make sure that your grinding machine stands
upright and stable on a solid surface with sufficient
lighting.
The machine has no front or rear side. Grinding can
take place either with or against the direction of rota-
tion.
The grindstone is not pre-assembled for packaging
reasons
GB | 25