Idiomas disponibles
Idiomas disponibles
Flash warning system for hypertensive readings
If the measured values fall within the hypertension range, the reading
displayed on screen flashes on and off to alert user.
According to JNC 7 Classification, values consistently in excess of 140 mmHg
(Sys.) and/or 90 mmHg (Dia.) are considered to constitute high blood pressure.
frm
E
DIASTOLIC
mmHg,
prisa
rís
mm
id GE / = »
ha
m) =I
05 >
$
Hypertension
al tI Y
OE
`
ic
(Stage 1, Stage 2)
4-
7x
pulse/min.
90
Prehypertension
80
+ Blood pressure readings will flash for approx.
6-seconds when in the high blood pressure
range.
120
140 (mmHg)
Systolic blood pressure:
140 mmHg and over
Systolic
Diastolic blood pressure:
90 mmHg and over
(Only when measurement is complete)
When an Error Occurs During Measurement
SYSTOLIC
mhg DIASTOLIO mik
An E will appear on the display to
E
indicate
that
measurement
was
L
unsuccessful and should be performed
puse/mn
again.
Before performing
another measure-
ment, always press the On/Off and Start button to turn off the unit and make
sure to allow a rest period of 4 to 5 minutes before starting again.
Please consult your doctor without delay if the blood pressure indicator
repeatedly draws attention to elevated blood pressure values.
Advice:
In general,
blood
pressure
measurements
are lower for the second
measurement because you are less nervous and are more tranquil.
For people who easily get tense, measuring twice each time is very effective.
When two measurements
are taken, normally the smaller measurement is
stored.
When taking two measurements, always stay quiet for 4 to 5 minutes after
the first measurement before taking the second measurement.
16
