Bosch 52314 Instrucciones De Funcionamiento Y Seguridad página 13

CHARGING BATTERY PACK (30 MINUTE DUAL BAY-BC230)
INDICATORS, SYMBOLS AND MEANING
If the indicator lights are "OFF", the charger
is not receiving power from power supply
outlet.
k_ _t If the red indicat°rlight is
"ON",
the battery
pack is too
hot or cold for fast-charging.
The charger will switch to trickle charge, until
a suitable temperature is reached, at which
time the charger will switch automatically to
fast-charging.
I-_.- { _1 If the red indicat°r light is
- - "BLINKING", the battery pack
cannot accept a charge or
the contacts of the charger or battery pack
are contaminated. Clean the contacts of the
charger or battery pack only as directed in
these operating instructions or those
supplied with your tool or battery pack.
_ _[i-_ If the green indicat°r light is
" "BLINKING", the battery pack
is being fast-charged. Fast-
charging will automatically stop when the
battery pack is fully charged.
I I ,,i 1If the green indicator light is
_|"ON", the charger is plugged
= Jin but the battery pack is not
inserted, or the battery pack is fully charged
and is being trickle charged.
Plug charger cord into your standard power
outlet. Before inserting battery pack, remove
protective cap, then insert battery pack into
charger (Fig. 9).
The charger's green indicator light will begin to
"BLINK". This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is
fully charged.
When the indicator light stops "BLINKING"
(and becomes a steady green light) fast
charging is complete.
The battery pack may be used even though
the light may still be blinking. The light may
require more time to stop blinking depending
on temperature. When you begin the
charging process of the battery pack, a
II=l[_]
BATTERY
PACK
steady red light could also mean the battery
pack is too hot or too cold.
The purpose of the green light is to indicate
that the battery pack is fast-charging. It does
not indicate the exact point of full charge.
The light will stop blinking in less time if the
battery pack was not completely discharged.
When charging several batteries in
sequence, the charge time may slightly
increase.
When the battery pack is fully charged,
unplug the charger (unless you're charging
another battery pack) and slip the battery
pack back into the tool.
To prevent fire or injury when batteries are
not in tool or charger, always place protective
cap onto end of battery pack.
PROTECTIVE
CAP
--CHARGER
RED .IGHT GREE1 LIGHT
-13-