Idiomas disponibles
Idiomas disponibles
Settings
Controlled mechanical ventilation. (Activated by default) Allows you to enable or disable
ventilation activation. If it is enabled, the ventilation settings will appear in the user zone view.
The following parameters can also be configured from Airtools:
•
Steady ventilation. (Deactivated by default) Allows you to enable steady ventilation
regardless of the CO
Sensor will remain active at V
•
Vmax. (10 V by default) Defines the maximum working voltage of the fan.
•
Vmin. (0 V by default) Defines the minimum working voltage of the fan.
Variable selector. Allows you to select each variable to configure the ranges and weights that
influence the calculation of the Indoor Air Quality index.
Variable range. Allows you to configure the Good - Medium - Low status limits for each variable
according to the user's criteria. The default values will be indicated in the table at the end of
this document.
Variable weight. Allows you to select the weight of each variable in the calculation of the
Indoor Air Quality index. The weight is selected in a drop-down menu with 10% intervals from
0% to 100%. If a weight of 0% is selected, the variable will not be taken into account in the
calculation of the Indoor Air Quality index. If a value greater than 0% is assigned in variable
weight, the variable will be included in the calculation of the Indoor Air Quality index. The
default values are:
•
CO
: Weight assigned by default 80%.
•
2
TVOC: Weight assigned by default 20%.
Reset to default values. Resets the default range and weight configuration.
or TVOC measurement status where the 0-10 V output of the AirQ
2
.
min
9
