Idiomas disponibles
Idiomas disponibles
2
16
- EN
4.1-4
4.1-4a
1
2
4.1-5
Only for Tubeless wheel models:
F1. Press bead seater/infl ator pedal (1, Fig. 4.1-4) on left
side of the machine half way down: air will come from
infl ation hose end only (2, Fig. 4.1-4).
F2. Press bead-seater pedal (1, Fig.4.1-4) down swiftly
to get air blast from the turntable jets (3, Fig.4.1-4).
Note:
Air simultaneously continues to exit the hose
(2, Fig. 4.1-4) connected to the tire.
WA R N I N G : O N C E B E A D I N G I S C O M P L E T E ,
IMMEDIATELY STOP INTRODUCING AIR.
3
(Fig. 4.1-4a)
WHEN OPERATING THE BEADING DEVICE IT IS
MANDATORY TO WEAR EAR PROTECTORS AND
SAFETY GLASSES TO PREVENT CONTAMINATION
FROM NOISE, DUST AND CHIPS BLOWN BY THE AIR
JETS.
DANGER OF TIRE EXPLOSION
Presetting of clamping jaws:
N.B.: Turntable capacity can be changed before pedal
control.
The turntable jaws can be positioned in three different
ways (Fig. 4.1-5).
Push the lever (C) on the left side of each jaw and shift at
the same each one (0/+2"/4").
VERY IMPORTANT: LOOK FOR PROPER INSERTION
OF THE PIN
CAUTION! MAKE SURE ALL FOUR CLAMPING JAWS
ARE MOUNTED IDENTICALLY (1 OR 2, FIG. 4.1-5).
OTHERWISE THE RIM MAY COME LOOSE AND INJURE
THE OPERATOR!
Rim diameters are shown in inches on the turntable (A,
Fig. 4.1-5). The diameter setting (mark on jaw (B) must
coincide with mark on turntable) depends on the clamping
jaw position 1 or 2.
• In jaws position 1 the diameter is preset directly (1,
Fig. 4.1-5).
• In jaws position 2 (2, Fig. 4.1-5) 4 inch must be added
to the diameter.
