GE 16 Serie Manual Del Propietario E Instalación página 5

About the fresh food compartmentshelves.
Shelf supports at various levels allow you to custom-space your shelves. Not all features are on all models.
ITlTilt up
Half-Width Shelves
One end ot the shelf rests on a molded
side-wall support; a bracket on the other
end hooks into a track on the rear
cabinet wall.
To remove, lift the
shelf
up at fl'ont,
then
off the stlpport and otlt of the track.
To replace, select desired shelf height.
_,_ith shelf front raised slightly, hook the
bracket's top lug into the track, then
h)wer the shelf onto the support.
NOTE: Theshelf to theright of the trackis
des/)ned to hookinto theright-handslot,
theshelf to the left is designedto hook
into the left-handdot
Full-Width Shelves
Some models have a steel wire sliding
shelf, a stationa_ T teml)ered glass shelf or
two steel wire stationary shelves. These
shelves can be moved to another place
in the fresh fl)od compartment.
The fifll-width sliding shelf has stop-locks.
When placed correctly on the shelf
SUl)ports, the shelf will stop heft)re coming
completely ()tit of the reli'igerator and will
not tilt when you place food on it or
ten/eve fi)od from it.
To remove the full-width shelves, lift the
rear of the shelf and pull forward,
To remove a full-width shelf when the fresh
food compartment door cannot be opened
fully, lifi the rear ot the shelf, pull
fin'ward and down, tilt the shelf and
take it out.
II II
Spillproof Shelves (onsomemodels)
Spillproof shelves have special edges
to hel I) prevent spills from dfil)l)ing
to lower shelves. To remove or replace
the shelves, see the above instructions.