Black and Decker NST2018 Manual De Instrucciones página 10

• Toconvert formaintenance edging, turn off t he tool. A sshown
infigure 12, h old the trimmer with one hand b ythe auxiliary
handle, grasp t he collar and push indirection ofarrow and
rotate t he trimmer head u ntil itstops, (half turn), release your
hand, (rotate clockwise when v iewed from the switch e nd).
The toot i slocked i nthe edger position.
Rotate the wire edge guide f orward and down i nto place
before edging, asshown i nfigure 13.
• Tooperate asamaintenance edger, position trimmer above
sidewalk asshown i nfigure14. T he edge g uide c anrest o n
the edge o fthesidewalk tohelp provide aclean a nd
consistent cut.
• Return totrimming position byturning the toot o ff, p ush in
direction ofarrow and rotating the trimmer head c ounter
clockwise until itstops. When u sing t he tool i nthe trimmer
mode y ou may choose tofold thewire edge guide u pout
ofthe way.
Line Feeding
Your trimmer uses .065 in. (1.65mm) diameter nylon line to
cut grass and weeds quickly and easily. In time, the tip of the
nylon line will become worn and the auto feed mechanism will
automatically feed and trim a fresh length of line.
The cutting line wilt wear faster if the cutting is done along sidewalks or other abrasive
surfaces or if heavier weeds are being cut. The automatic feed mechanism senses when
more cutting line is needed and feeds and trims the correct length of line whenever it
is required. No action is required to advance the line. Do not bump unit on ground in
attempt to feed line or for any other purpose.
Replacing Spool/Clearing Jams and Tangled Lines
From time to time, especially when cutting thick or stalky
weeds, the line feeding hub may become clogged with sap or _ ,/
other material and the line witt become jammed as a result.
To clear the jam, follow the steps listed below.
• Turn off the trimmer and remove the battery, lOO-
• Press the release tabs on the line spool cover, as shown in _._,,,z_/-., ....d
figure 15 and remove the cover by pulling it straight off. _/-
• Lift the spool of nylon line out of the hub and clear any broken
line or cutting debris from the spool area.
10