Idiomas disponibles
Idiomas disponibles
CHARGING
WARNING: The charger and battery pack
are specially designed to work together so
do not attempt to use any other devices. Never
insert or allow metallic objects into your charger
or battery pack connections because of an
electrical failure and hazard will occur.
Your battery pack is UNCHARGED and you must
charge once before use
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not use
another battery charger.
1. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit. In a warm environment or after heavy use,
the battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
2. TO REMOVE OR INSTALL BATTERY PACK
(See Fig. C)
Depress the battery pack release button to
10
release and slide the battery pack out from your
tool. After recharge, slide it back into your tool. A
simple push and slight pressure will be sufficient.
OPERATION
1. SAFETY ON/OFF SWITCH (See Fig. D)
Your switch is locked off to prevent accidental
starting. Depress the lock-off button (1) then the
on/off switch (5) and release lock-off button (1).
Your switch is now on. To switch off just release
the on/off switch.
2. WORKING INSTRUCTIONS
NOTE: Hold the machine away from yourself.
Stand in a secure and stable position.
WARNING: Always clamp and support
workpiece securely. Do not touch blade
to workpiece until saw reaches full operating
speed.
HOW TO GRASP YOUR WoRX HANDY SAW
Grasp your Worx Handy saw as shown in Fig E,
for best control of the tool and comfortable use
as a reciprocating saw.
Cordless Li-Ion handy saw
GENERAL CUTTING (See Fig. F1, F2)
NOTE:
1. Always use a blade suited to the material and
material thickness to be cut. The quality of
cut will improve as the number of blade teeth
increase.
2. Always ensure the workpiece is firmly held or
clamped to prevent movement. Support large
panels close to the cut line. Any movement of
the material may affect the quality of the cut.
3. The blade cuts on the upward stroke and
may chip the uppermost surface or edges of
your work piece when cutting, ensure your
uppermost surface is a non-visible surface
when your work is finished.
OPERATION:
1. Mark the line of cut, clearly before your
cutting.
2. Do not force the tool. Place the steel base (9)
firmly on the workpiece while cutting. Use only
enough steady pressure on the blade to keep
the saw cutting.
3. Reduce the pressure as the blade comes to
the end of the cut.
4. Allow the saw to come to a complete stop
when before removing the blade from the
workpiece.
TREE TRIMMING
Use wood blade when cutting tree branches. Hold
steel base firmly against tree brance. Cut close to
the branch of the tree to decrease movement of
the branch being cut.
METAL CUTTING
Use a finer tooth blade for ferrous metals and a
coarse tooth blade for non-ferrous metals. When
cutting thin sheet metals always clamp steel
on both sides of the sheet to reduce vibration
or tearing of the sheet metal. Do not force the
cutting blade when cutting thin metal or sheet
steel as they are harder materials and will take
longer to cut. Excessive blade force may reduce
the life of the blade or damage the motor. To
reduce heat during metal cutting, add a little
lubricant along the cutting line.
MAINTENANCE
Remove the battery pack from the tool before
EN
