Idiomas disponibles
Idiomas disponibles
3.
Use of side guards
•
On both sides of the seat, there are side guards on its outer walls. To activate the
guard, press it down. Deactivate by pressing the guard again (figure 18).
WARNING! Only the guard that is next to the vehicle door needs to be activated. If the
extended guard touches the door directly or gets caught on it, it should not be used.
4.
Backrest tilt adjustment
•
To adjust the tilt of the backrest, use a special handle under the front part of the seat
(figure 19).
•
Pull the handle, set the desired tilt, and release the button (figure 20).
•
The seat has a 5-stage backrest tilt adjustment. The arrow shows in which position the
seat is currently positioned (figure 21).
WARNING! The tilt adjustment only serves to adjust the seat against the backrest of the car
seat! The backrest of the seat should lie flush with the backrest of the car seat.
5.
Care and maintenance
Removing and fitting the cover.
•
Unhook the two pins located on the back of the headrest (figure 22).
•
Unhook the rubber bands holding the headrest cover material (figure 23, 24A/B).
•
Remove the cover from the headrest (figure 25).
•
Gently remove the cover from the seat, sliding it along the backrest (figure 26, 27).
•
Gently slide the backrest cover out from under the headrest (figure 28).
•
Pull the sides of the seat cover, sliding it out of the guides (figure 29).
•
Slide the bottom of the seat cover out through the lower guide (figure 30).
To reinstall the cover, follow all the steps described in this section in reverse order.
Maintenance
Do not grease any part of the car seat. Keep it in a safe place when not in use. Avoid direct
sunlight or direct contact with a heat source.
Cover:
Wash at max. 30°C, gentle
process.
Do not dry in a tumble dryer
Do not dry clean
The seat cannot be used without the cover.
Plastic parts: can be cleaned with soapy water. Do not use strong detergents (such as solvents).
6.
Durability of the seat
The seat has been designed and made to retain its characteristics for 9 years from the date
of manufacture. However, it is important to remember to operate and maintain it properly.
•
The seat should not be exposed to prolonged sunlight. When not in use, the seat
should be removed from the vehicle or covered with a light fabric.
•
It is recommended to regularly check the condition of plastic and metal parts of the
seat, paying special attention to any damage, colour changes or deformations.
If any part of the seat is damaged or loose, stop using the seat. Any impact and collision
caused by a road traffic accident prevents the continued use of the seat - the seat must be
replaced
•
Changes in the colour of the material, including fading, are a natural characteristic of
the product and do not impair the safety of the seat.
•
Once the expiry date of the seat has been reached, stop using it and dispose of it.
7.
List of vehicle types
When the child's height exceeds 135 cm, fitting of the seat in the car may be limited. Please
refer to the list of vehicle types at the end of this manual to make sure the seat can be used
in your vehicle. This list is for illustrative purposes only. It is recommended that you compare
the seat's size with your vehicle before purchasing.
8.
Warranty conditions:
1.
The warranty is provided by skiddoϋ Polska Sp. z o.o. with its main office at
Kopanina 34, 60-105 Poznań, Poland.
2.
The warranty covers skiddoü brand products.
Do not bleach
Do not iron
11
