Idiomas disponibles
Idiomas disponibles
POWER CONNECTIONS (Fig. 6):
@
To Remote-On or Power Antenna turn-on wire of the Head Unit
NOTE:
+12V should be supplied to this terminal to turn on the 3402. If your Head
Unit does not have a Remote-On wire, a SPST switch must be connected between an
ignition source and the 3402 Remote-on terminal. Then the 3402 can be turned on
manually by closing this switch.
Connect to a bare metal part of the vehicle chassis. Ground all audio components to
the same point to avoid ground loops.
Use a 5 A in-line fuse as close as possible to the Battery + terminal.
Connect directly to the battery + terminal.
Remote-On (blue/white)
Ground (black)
Battery (yellow)
5 A Fuse
Battery
QLLEG88
8
AUDIO CONNECTIONS:
@
4-CHANNEL/1-INPUT SYSTEM CONNECTION (Fig. 7):
@
To Front Channel Equalizer, Active Dividing Network or Power Amplifier
@ Signal Source
@® To Rear Channel Equalizer, Active Dividing Network or Power Amplifier
@
4-CHANNEL/1-INPUT SYSTEM CONNECTION (Fig. 8):
® Signal Source
®
To Front Channel Equalizer, Active Dividing Network or Power Amplifier
@® To Rear Channel Equalizer, Active Dividing Network or Power Amplifier
* DO NOT USE
@
2-CHANNEL SYSTEM CONNECTION (Fig. 9):
@_ Signal Source
To Equalizer, Active Dividing Network or Power Amplifier
* DO NOT USE
15
