Idiomas disponibles
Idiomas disponibles
1. Load the dishes.
Remove any scraps of food in advance.
Pull
the lower rack out and load the dishes and
cutlery in and push it all the way back. Pull
the upper rack out and load the cups,
glasses, etc.
2. Turn on the dishwasher.
When ready to run a cycle, open the door and
press the power button. The dishwasher
defaults to the normal cycle.
6. Close the door. The dishwasher
starts automatically after a
slight delay.
7. At the end of the Program.
End is displayed on the digital display for a
few seconds and a tone will sound, signaling
program completion.
The dishwasher
automatically
switches off for safety and
energy savings.
3. Check rinse-aid.
The indicator lights will illuminate if the rinse
aid level is low.
The estimated remaining time will be displayed, ff the
door b opened daring operation, the dishwasher stops'.
Once the door is dosed, the program will mstal_t [_vm
the point where # stopped.
one, this will avoid water dripping from the
upper
rack onto the dishes in the lower one.
.
.
Measure the detergent.
Add the required amount of detergent into the
dispenser.
Close the detergent dispenser
lid.
Setting the program.
Select desired program and options.
Before starting, the display window will show
the estimated running time of the selected
program. If the number of dishes fills only one
rack, you can use the Half Load option. For
example, if you load dishes only on the upper
rack, you adjust the Half Load button to the
upper rack.
Remember
to load all dishes
into
the
selected
rack.
The estimated remaining
time wilt be
displayed.
If the door is opened during operation, the
dishwasher
stops.
Once the door is closed, the program will
restart from the point where it stopped.
In general,it
is not advisable t 0 oPen the door
whi!e the dishwasher
is running, If the doo r is
opened, a safety device stop s the machine:
Care should be taken whe n opening the door
immediately
following the cycle! as steam may
escape.
Auto-Off
_,,,,,,,,,,,,,,,,,,,:
Dual IntensityTM Wash Cycle
Course Selection
-_ Press SPRAY key for 3
sec. -_ SPRAY selection
for upper spray
(Strong/Medium/soft/off)
-_ Press HALF LOAD
to select
lower rack -_ SPRAY selection
for
lower spray(Strong/Medium/soft/off)
_ Check
selection
by press HALF LOAD _ Another
option -_ Door Closed -_ Start
