Idiomas disponibles
Idiomas disponibles
Using the Controls - Electronic Control Models
Getting Started
1. Add detergent
and additives to the washer.
2. Load the washer.
3. Close the lid.
4. Select the appropriate
cycle and options for the load.
5. Press the Cycle Selector
dial.
6. The Fill indicator
light will illuminate
and the washer
will start to fill.
Note:
The lid must be completely
closed in order
I
to operate the washer controls.
I
Select Water Level
Determine
the selected setting based on clothes load
size. Selection should provide sufficient
water to permit
clothes to circulate freely during agitation.
It may become necessary, due to bulky fabrics, to
adjust the water level after agitation
begins. To adjust
the water level, turn the Infinite Water Level control to
reset and then back to the desired setting.
Small
1/4-
1/3
Medium
1/3-
1/2
Large
1/2 - 2/3
Super
2/3 - Full
Select Wash/Rinse Temperature
Your washer gives you a choice of hot, warm or cold
water for washing and cold water or warm water
(select models) for rinsing. Use the chart below as a
guide.
Automatic
Temperature
Control (A.T.C.) provides
the optimal wash water temperature
for cleaning. To
save energy, this washer will regulate wash water
temperatures
by mixing hot and cold water to reach
the proper water temperature.
Cold/Cold
Brightly colored, lightly soiled
(select models)
items; washable woolens.
These settings feature Automatic Temperature Control:
Saves energy by adding cold water
ATC Hot/Cold,
to the hot water from your water
ATC Warm/Cold
heater. Provides optimum
cleaning
at lower temperatures.
May add hot water to the incoming
cold water as the washer fills. This
ATC Cold/Cold
assures that the water will be warm
enough to properly activate detergent.
