Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4. For low-voltage cable connections, split one end
of the low-voltage cable approximately 2 in., and strip
about 3/4 in. of insulation off each wire, then twist
strands together tightly.
5. Distribute the light fixtures as evenly as possible
along the low-voltage cable. Position the higher
wattage fixtures closer to the power pack
(H)
and
lower wattage fixtures away from it. Note: The first
fixture should be at least 10ft. away from the power
pack
(H).
6. Determine the distribution of lights and calculate the total
length of low-voltage cable that is needed to go around
and return to the power pack
(H).
Make sure not to cross the wires when routing them back
to the term ina I blocks. The wire coming from a
particular terminal screw must go back in the same
terminal screw. Note: The wire has a smooth side and a
rigged side for identification.
Please make sure the cables are securely connected to
the power pack
(H)
to prevent fire, electrical shock or
damage to the power pack
(H).
7
____ 1·_2_?:
&14iW.
12VAC OUTPUT
Lowes.com/portfolio
