Idiomas disponibles
Idiomas disponibles
2.
Place your index finger between the two lines to stop
the lines from overlapping (see Fig. 32).
3.
Wind both lines at the same time in even and tight
layers onto the reel, in the direction indicated on the
reel (Fig. 32).
NOTE: Failure to wind the lines in the direction indicated
will cause the cutting head to operate incorrectly.
4.
insert one line end into each holding slot (Fig. 33).
Reinstalling the Reel
1. insert one line end through each of the eyelets in the
reel housing, and insert the reel and spring back into
the reel housing (Fig. 34).
2.
Grasp the line ends and pull firmly to release them
from the holding slots in the reel.
3.
Hold the reel in place and screw the Bump Knob
TM
counterclockwise
back onto the reel (see Fig. 29).
TO INSTALL A PREWOUND
REEL
1. Hold the reel housing with one hand and unscrew
the Bump Knob clockwise (Fig. 29). Inspect the bolt
inside the Bump Knob to make sure it moves freely.
Replace the Bump Knob if damaged.
2.
Remove the old reel from the reel housing (Fig. 29).
3.
Remove the spring from the old reel (Fig. 29).
4.
Use a clean cloth to clean the inner surface of the
reel housing (Fig. 39).
5.
Place the spring in the new reel.
NOTE: The spring must be assembled on the reel before
reassembling the cutting attachment.
6.
insert the ends of the line through the eyelets in the
reel housing (Fig. 34).
7.
Place the new reel inside the reel housing. Push the
reel and reel housing together. While holding the reel
and reel housing, grasp the ends and pull firmly to
release the line from the holding slots in the reel.
8.
Hold the reel in place and install the Bump Knob by
turning counterclockwise.
Tighten securely.
Reel F--
Fig. 32
Fig. 33
Reel
Housing
Holding
Slots
i
/
/
//
/
/
/
/
/
Fig. 34
- 20 -
