Robern CRAFT Serie Instrucciones De Instalación página 3

ASSEMBLY
3. Apply a 1/4" (6 mm) bead of clear sealant (latex caulk/silicone) on vanity edge. Place the top onto the vanity and push until flush
with the back of the vanity. Adjust position until the top has an equal overhang on each side of the vanity.
IMPORTANT! To ensure proper installation and sealant bond, align and lower the sink top into place as close as possible to reduce
the need to make large adjustments.
NOTE: If the integrated top is not being mounted to a compatible Robern vanity, proceed to Step 5.
4. Secure the top to the vanity using a supplied screw [203-1532] and washer [203-1535] through each clearance holes on either end
of the vanity. Each screw should travel through a bracket [210-1776, attached in Step 1] and then secured with a washer [203-1535]
and wing nut [203-1534]. Hand tighten the wing nuts until the top is secure to the vanity.
5. Verify that the sink top is level. Wipe away excess sealant. Allow the sealant to set according to the manufacturer's instructions.
6. Connect the trap to the drain. Complete all plumbing connections and run the water and check for any leaks.
7. Install drain cover(s) into the sink bowl(s), positioned over locating points.
3
5
© 2021 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
4
6
3
7
Part no. 209-1414 11/10/2021
Craft Series Integrated Basin