GYS EASYCUT 25 Manual Del Usuario página 19

PART PIERCING / CUT IN THE MIDDLE OF THE PART
With the earth clamp is fastened to the part, maintain the torche at an angle of
1
roughly 30° to the part.
Press the torch's trigger to start the arc while maintaining an angle of 30° to the
2 part. Slowly rotate the torch
towards a perpendicular position (90°).
Immobilise the torch while keeping the trigger pressed. If the sparks come from
3
below the part, the arc has cut the material.
4 Once the part is cut, slightly drag the tip on the part to continue the cut. Try to maintain a regular rythmn.
CONSUMABLES INSPECTION (ASSEMBLY AND DISASSEMBLY, SEE P.16)
Parts
Check the for damage and surface wear.
Nozzle
Visually check the tip's internal hole.
Tip
Check for damage and wear on the surface and inside the diffuser.
Check that the fumes' exhausts are not obstructed.
Diffuser
Visually check the electrode's internal hole.
Electrode
.
EASYCUT
Actions
OK
OK
Solutions
Replace the nozzle when it looks damaged (traces of
burns).
Replace the tip if the inner diameter is enlarged or
distorted.
NOK
Replace the diffuser if the surface is damaged or
worn, or if fume exhausts are obstructed.
Replace electrode when the insert is used (removal of
1.5 mm).
NOK
EN
19