Idiomas disponibles
Idiomas disponibles
Line
Cutting
Blade
Twist & Edge and
Craftsman
Convertible
TM
Coupler
Shaft
Housing
On/Off Stop
D-Handle
Control
\
Muffler
Starter Rope
Grip X
Shaft Grip
\
Throttle
Control
Air Filter Cover
Spark
Oil Fill Plug
Plug
Fuel Cap
Choke Lever
Primer Bulb
Cutting Attachment
Shield
HassleFree
TM
INSTALLING AND ADJUSTING THE D-HANDLE
1.
Remove the screws and bottom clamp piece that were
installed on the D-handle for shipping.
2.
Place D-handle the over the shaft housing and onto the
bottom clamp (Fig. 1). Place it a minimum of 6 inches
(15.24 cm) from the end of the shaft grip.
3.
Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the handle
adjustment.
4.
If the D-handle was pre-installed,
loosen the screws on the
handle just enough to move it.
5.
While holding the unit in the operating position (Fig. 13),
position the D-handle to the location that provides you the
best grip.
On/Off Stop Control
._
Shaft
Housing
(4) Screws
Shaft Grip
Minimum 6
(15.24 cm)
D-Han_
Fig. 1
Bottom Clamp
6,
secure,
INSTALL LINE TRIMMER
ATTACHMENT
NOTE: To make installation easier,
place the unit on the
ground or on a workbench.
1.
Turn knob counterclockwise
to
loosen coupler (Fig. 15, p. 8).
2.
While firmly holding attachment,
push it straight into the coupler
until the release button snaps
into the primary hole (Fig. 16, p.
9).
NOTE:
Aligning the release button
with the guide recess (Fig.
16, p. 9) will help
installation.
Tighten the clamp screws evenly, until the D-handle is
3.
Turn the knob clockwise to
tighten.
LINE TRIMMER
APPLICATIONS
Fig. 2
Cutting grass and light weeds; edging; and decorative trimming
around trees, fences, etc.
