cecotec BOLERO FLUX PM Manual De Instrucciones página 68

ENGLISH
Replacing the light bulb/lamp
Please note:
- The light bulb must be replaced by the official Cecotec Technical Support Service or
similarly qualified technicians.
- Always disconnect the power supply before performing any operation on the appliance.
When handling the bulb, make sure that it has cooled down completely before any direct
contact with your hands.
- When handling the bulbs, hold them with a cloth or gloves to prevent sweat from coming
into contact with the bulb, as this may reduce the bulb life.
Note:
- Before changing the light bulb, make sure that the appliance is switched off and unplugged.
- Protect yourself from danger when changing the light bulb, e.g., by wearing gloves.
- Technical data of the light bulb/lamp: 220 V AC – 1.5 W
6. TROUBLESHOOTING
Problem
The light is on, but the
motor does not work
Neither the light bulb nor
the motor works
Grease falls out of the
aluminium filters
68 BOLERO FLUX PM 906500 BLACK A / INOX A
Cause
The kitchen hood is obstructed. Remove what is obstructing
The condenser is damaged.
Motor is jammed or bearing
damaged.
Motor is burnt or gives off a
bad smell.
In addition to the above, check the following:
The light bulb has blown.
Power cable is loose.
The filters are very dirty.
Solution
the hood.
Replace the condenser.
Replace the motor.
Replace the motor.
Replace the light bulb.
Connect the cables
according to the wiring
diagram.
Clean or replace the
aluminium filters
immediately.