cecotec BOLERO FLUX PM Manual De Instrucciones página 66

ENGLISH
- To facilitate air outlet, the ventilation duct should have a curvature of ≥120° and should be
connected to the outside wall.
- After installation, ensure that the kitchen hood is level to prevent grease build-up on the
end. Fig. 3
1. The kitchen hood should be placed at a distance of 65-75 cm above the cooking surface
for best effect.
2. Install the wall hook in a suitable location and set the installation height. Keep it aligned.
Use the screws to fix it to the wall.
3. Fix the outer bracket on the chimney, and make sure that the inner part of the chimney can
be adjusted to the installation height, as well as that of the flexible connection pipe. Then,
install the flexible connection pipe in the chimney of the kitchen hood.
4. Place the kitchen hood on the hook on the wall.
5. Adjust the height of the inner part of the chimney to the position of the inner bracket and
fix it with screws (ST4*8 mm). After adjusting the position of the kitchen hood, fix the body
with safety screws (ST4*30 mm).
Note: There are two safety ventilation ducts in the back housing.
Figure 4 shows the necessary elements to install the kitchen hood, bracket, and hooks.
4. OPERATION
Power buttons
1. To switch on the kitchen hood, press any of the power buttons.
2. If you press the low power button, the kitchen hood will beep, and the motor will operate
at low speed.
3. If you press the medium power button, the kitchen hood will beep, and the motor will
operate at medium speed.
4. If you press the high-power button, the kitchen hood will beep, and the motor will operate
at high speed.
5. If you press the light button, both bulbs will light up. Press it again and the light will switch
off.
6. Press the off button, the motor will switch off.
66 BOLERO FLUX PM 906500 BLACK A / INOX A