Idiomas disponibles
Idiomas disponibles
Installing the appliance
please follow the sequence to put
on pan support
(A) SEALING STRIP
(C) SCREW
of the screws.There are one set of screw holes in each
corner of the hob (H) .
Slightly tighten a screw (C) through the bracket (B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
. 2 Carefully turn the hob back over and then gently lower
it into the aperture hole that you have cut out.
. 3 On the underneath of the hob, adjust the brackets into
a position that is suitable for your worktop.
(B) BRACKET
Then fully tighten the screws (C) to secure the hob into
position.
eput the left/right pan support
on the glass follow the naile
2. Tear off the paper.
3. Stick the sponge round the edge of the
cut-out hole.
put the left/right pan support
on the glass follow the nail
2 put the middle pan support between
them.
Do not use a silicon sealant to seal the
appliance against the aperture.
16
