Idiomas disponibles
Idiomas disponibles
Maintenance
Maintenance Schedule
These required maintenance procedures should be performed at the frequency stated in the table to ensure that
your unit continues to meet the 1995 California emission regulations. They should also be included as part of any
seasonal tune-up.
Frequency
Before starting engine
Every 10 hours
Every 25 hours
Every 50 hours
Line Installation
The trimming line may be replaced by two different
methods — rewinding the existing reel or installing a
prewound reel.
Rewinding the Existing Reel
To rewind the existing reel you must:
1.
Check for the correct line size.
2.
Remove the existing reel and spring.
3.
Wind the existing reel with the new line.
4.
Reinstall the existing reel and spring.
Maintenance Required
Fill fuel tank with correct oil and fuel mixture.
Clean and re-oil air filter.
Inspect and clean muffler.
Check spark plug condition and gap.
The Correct Line To Use
POTENTIAL HAZARD
Use of improper line could cause line to
break and be thrown in operator's or
bystander's direction.
WHAT CAN HAPPEN
Use of improper line could result in serious
personal injury.
HOW TO AVOID THE HAZARD
Use only Toro approved replacement
monofilament line.
Do not use any type of wire or other
string–like substance. Do not use
metal-reinforced line.
It is very important to use the correct size line. A line
with a diameter of .095 in (2.41 mm) must be used.
The engine may overheat and fail if you use a
larger line.
Removing The Existing Reel
1.
Stop engine and wait for all moving parts to
stop. Pull wire off spark plug.
Refer to:
Page 8
Page 12
Page 14
Page 14
EN–10
