Hitachi SPX-WKT1 Instrucciones De Instalación Y Manual De Operación página 6

2. Attach the controller to the holding bracket as follows.
1. Fix the holding bracket onto wall
as shown right.
2. Cut the top of the front cover and
make a draw-out hole.
3. Lead the cable along the slot.
* Longer cable is prepared
as an option. (SPX-WDST : 15m)
4. Insert the hooks of the controller to
the holes on the top of the holding
bracket. Push the lower part toward
the holding bracket. When the click
sound is heard, the controller is
attached to the holding bracket and
the mounting work is finished.
CAUTION
Pay attention so that the cable may not be bitten.
It may cause a faulty operation.
INSTALLATION AND OPERATION MANUAL
B
A
*
* Forced RESET terminal
Fix the holding
bracket with
the mark "UP"
upward.
Screw
(Accessory)
Cut and make a draw-out hole.
Upward
NOTE :
If there is no indication or some
irregular indication is found when
the POWER is ON for the first
time, remove the controller from
the holding bracket (with the
cable connected) and short-circuit
between A and B.
Then forced RESET is operated.
3
Lead the cable
along the slot.