Power Supply; Installing The Printer; Inserting Paper - Mettler Toledo RS-P25 Manual De Instrucciones

Printer P25, P26, P28
6

2.2 Power Supply

The power supply of the printer is integrated in the housing (100-240 V, 50-60Hz). This allows
you to connect the Printer to your local line voltage.

2. Installing the Printer

The Printer detects the settings of the Instrument. Make sure that you proceed as
follow:
➊
Connecting the printer to the instrument
➋
Switching the printer on
➌

Inserting paper

3
4
Attention
• Connect the Printer only to AC Power receptacles with a connection to
ground!
• Use an extension cable with an equipment grounding conductor!
ïžð
2
1
• Attach the interconnect cable to the printer
interface of the instrument and to the printer.
• Switch the instrument on
• Connect the Printer to the mains power.
• Use the main switch <I/O> to power on.
• RS232 interface only: the pilot lamp will flash
until an instrument is connected. If the lamp is
still flashing check chapter 7.
I/O
• Remove paper cover (pull on the back) (1)
• Insert the paper rotary axis through the core of
the paper roll (2).
• Feed paper through the slot in the printing unit
in the direction of the arrow (3).
• Press and hold until enough paper has been
fed (4).
• Lead paper through the paper cover slot
• Replace the paper cover (1).