Idiomas disponibles
Idiomas disponibles
Installing cutting head
CAUTION:
Secure the cutting head firmly.
Otherwise the cutting head may rotate during opera-
tion and cause serious injury.
Insert the cutting head into the tool by turning it left and
right alternately. Then tighten the three bolts in the order
of A, B, C with the hex wrench (5/32").
Make sure the bolts are fastened with 5.1 - 5.7 N•m (45
- 50 in•lbs) before using the tool.
1 1
A
B
C
4
2
Fig.8
► 1 . Cutting head 2. Bolt 3. Hex wrench (5/32") 4. Tighten
Installing hook
WARNING:
Use the hanging/mounting parts
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING:
Be careful not to overload the hook
as too much force or irregular overburden may cause
damages to the tool resulting in personal injury.
CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook may
come off from the tool and result in the personal injury.
CAUTION:
Make sure to hang the tool securely
before releasing your hold. Insufficient or unbalanced
hooking may cause falling off and you may be injured.
1
2
3
Fig.9
► 1 . Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
3
1
2
3
OPERATION
Adjusting shear blade
Adjust the side blade L to prevent the curl of the
workpiece from contacting the cutting head and the
workpiece.
Loosen bolts with the hex wrench (5/32"). Move the
side blade L back and forth to adjust it. Then tighten the
three bolts with the hex wrench (5/32").
2
Fig.10
► 1 . Bolt 2. Side blade L
Lubrication
NOTICE:
Use the standard machine oil for steel
or the mineral spirits for aluminum.
Before operation, always lubricate the following areas:
A
The cutting area of the workpiece.
B
The part of the center blade which contacts to the
workpiece.
C
The both sides of the center blade which contacts
to the side blade L and side blade R.
B
A
Fig.11
8 ENGLISH
1
C
C
