Idiomas disponibles
Idiomas disponibles
4. Before mounting the trimmer head,
make sure that the inner flange and
flange cover are located correctly on
the motor shaft as shown in
(Fig. 10d &10e).
5. Align the drive shaft with the screw
hole of trimmer head, and then pre-
tighten the trimmer head onto the
shaft COUNTERCLOCKWISE.
6. Rotate the trimmer head to align the
slot in the flange with the shaft-
locking hole in the gear case and
insert the provided hex key into the
aligned holes to act as a stabilizer.
7. Wear gloves. Securely tighten
the trimmer head onto the shaft
COUNTERCLOCKWISE (Fig. 10f).
56-VOLT LITHIUM-ION COMMERCIAL 12" BRUSH CUTTER — BCX4500/BCX4500-FC
10d
Motor Shaft
10e
10f
Hex Key
Flange Cover
Flange
Trimmer Head
Upper Cover
35
