Idiomas disponibles
Idiomas disponibles
Reinstall Blade Assembly
Reinstall blade assembly in reverse order of
disassembly. Refer to Remove Blade Assembly
procedures.
Zone Start Models - When reinstalling crankshaft
protector, install but do not tighten mounting screws.
Insert a shim (a business card works well) between
protector and hub on blade retainer which helps
center protector. Tighten mounting screws and
remove shim. Continue installing blade assembly.
Torque blade bolt to 50 ft.-lbs. (68 N m).
BBC Models – Torque blade nuts to 15-27 ft.-lbs.
(20-37 N m).
Install Primer Guard
1.
Remove (2) hex head screws from right front
quadrant (Fig. 11). Leave quadrant in place.
2.
Install new primer guard on top of right front
quadrant with (2) hex head screws (Fig. 11).
2
1
Figure 11
1. Right front quadrant
2. Hex head screw (2)
3
3. Primer guard
Install New Throttle Control
Zone Start Models
1.
HP Models Only – Disconnect brake cable from
throttle control by removing E-ring (Fig. 12).
Discard E-ring.
2.
SP Models Only - Disconnect traction cable
from throttle control by removing E-ring
(Fig. 12). Discard E-ring.
4
3
Figure 12
1. Throttle control
2. Brake cable (HP model)
Traction cable (SP model)
3. Throttle cable
3.
Remove (2) hex head screws and (2) curved
washers securing throttle control to handle
(Fig. 12). Retain screws and washers. Discard
throttle control and throttle cable.
4.
Install new throttle control using (2) hex head
screws and (2) curved washers previously
removed.
5.
Connect new throttle cable to throttle control
using new E-ring.
Installation
1
6
5
6
7
2
4. E-ring
5. Hex head screw (2)
6. Curved washer (2)
7. Seal
EN–7
