Idiomas disponibles
Idiomas disponibles
Installation
Adjust Brake Cable
POTENTIAL HAZARD
BBC Models Only – Do not over–tighten
blade brake cable. Over–tightening could
cause blade brake to be pulled off brake
drum. If brake does not contact drum,
blade will not stop rotating when control
bar is released.
WHAT CAN HAPPEN
A rotating blade could cause serious
personal injury.
HOW TO AVOID THE HAZARD
Check the blade brake mechanism each
time brake cable is adjusted to ensure
brake is stopping blade in 3 seconds or less.
If blade does not stop rotating in 3 seconds
or less, bring unit to your local Authorized
Toro Service Dealer for inspection and
repair.
1.
Zone Start Models Only – CHECK
ADJUSTMENT (Fig. 17 & 18)—Move control
bar toward handle until slack in wire is removed.
Gap between brake lever and handle must be
3/16"–1/4". See step 2 for adjustment.
2.
ADJUST CABLE CONDUIT
Hand Push Models (Fig. 17)–Loosen jam
nut on brake cable. Insert 3/16"-1/4" object
between brake lever and handle. Turn cable
adjuster on brake cable until slack is
removed. Then tighten nut.
Self-propelled Models (Fig. 18)–Loosen
nut on cable bracket. Insert 3/16"-1/4"
object between brake lever and handle. Pull
down on cable conduit until all slack is
removed from wire. Then tighten nut.
EN–10
1
4
6
Figure 17
Hand Push Model
1. Handle
2. Brake lever
3. 3/16"-1/4"
2
Figure 18
Self-propelled Model
1. Handle
2. Brake lever
2
3
5
483
4. Cable adjuster
5. Jam nut
6. Cable conduit
1
3
4
3. 3/16"-1/4"
4. Cable bracket
