Idiomas disponibles
Idiomas disponibles
Installation
6.
HP Models Only – Reconnect brake cable to
throttle control using new E-ring. Then
reconnect brake cable to engine (Fig. 5).
7.
SP Models Only – Reconnect traction cable to
throttle control using new E-ring. Then
reconnect brake cable to engine (Fig. 5).
8.
Make sure seals on cables are pushed down tight
(Fig. 12).
9.
Route throttle cable across top of transmission
(Fig. 13).
1
Figure 13
1. Throttle cable
10. Connect throttle cable to throttle arm on engine
(Fig. 14).
Figure 14
1. Cable clamp screw
2. Cable clamp
EN–8
m-3638
3. Throttle cable
4. Throttle arm
11. Move throttle to
(FAST) position.
12. Push throttle arm to rear of engine as far as it
will go.
13. Install new cable clamp and cable clamp screw
to engine (Fig. 14). Tighten cable clamp screw to
lock throttle cable in place.
14. Reinstall belt cover using fasteners previously
removed (Fig. 3).
BBC Models
1.
Remove (4) Phillips head screws and (4) lock
nuts securing throttle control to control panel
(Fig. 15). Retain screws and lock nuts. Discard
throttle control, throttle control retainer and
throttle cable.
Figure 15
1. Phillips head screw (4)
2. Lock nut (4)
3. Throttle control
4. Throttle control retainer
5. Throttle cable
6. Seal
7. Decal P/N 98-2003
