Idiomas disponibles
Idiomas disponibles
Installation
DESCRIPTION
Rope Guide (BBC models only)
Curved Washer (BBC models only)
Hex Head Screw – 1/4-20 x 1.5 (BBC models
only)
Hex Lock Nut (BBC models only)
Before Installing
POTENTIAL HAZARD
If you leave the wire on the spark plug,
someone could accidentally start the engine.
WHAT CAN HAPPEN
Accidental starting of engine could
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Pull wire off spark plug before you install
kit. Also push wire aside so it does not
accidentally contact spark plug.
1.
Disconnect spark plug wire from spark plug.
POTENTIAL HAZARD
If gasoline is spilled on a hot engine, it
could ignite.
WHAT CAN HAPPEN
Contact with burning gasoline could cause
serious personal injury.
HOW TO AVOID THE HAZARD
Drain gasoline from a cold engine only.
2.
Make sure engine is cool. Remove cap from fuel
tank and use a pump-type syphon to drain fuel
into a clean gas can.
Note:
This is the only procedure
recommended for draining fuel.
EN–2
QTY.
1
1
Install new rope guide
1
1
3.
Reconnect spark plug wire.
4.
Even though the gasoline has been drained from
the engine, enough fuel should be left in the
carburetor bowl and fuel line to start the engine.
Start the engine and let it run until it runs out of
fuel. Briefly running engine will warm up the
oil.
5.
Disconnect spark plug wire from spark plug.
6.
Drain oil from engine. Refer to your operator's
manual for proper oil draining procedure.
Disassemble Old Components
Remove Starter Rope
1.
Zone Start Models Only – Remove starter rope
from rope guide (Fig. 1).
1. Rope guide
USE
1
2
Figure 1
2. Starter rope
m–2705
