Idiomas disponibles
Idiomas disponibles
Selecting self-propel speed (See Fig.J)
J
Selecting cutting speed (See Fig. K)
2 cutting speed levels can be selected depending
on the application. Use the +/- to control the speed,
which is as indicated by the LED indicators. The
higher the cutting speed level, the faster the tool
runs.
K
EN
MULCHING MOWING TIPS
While mulching, your new mower is designed to cut
the grass clippings into small pieces and distribute
them back into the lawn. Under normal conditions,
the mulched grass will biodegrade quickly and
deliver nutrients to the lawn. Please review the
following recommendations for optimum mulching
performance.
1) Avoid mowing when the grass is wet from rain or
dew. Wet grass may form clumps which interfere
with the mulching action and reduce the runtime.
2) For the best mulching performance, set the
cutting height to remove about one third of
the grass blade length, ideally no more than
1.5"/40mm at one time. If the lawn is overgrown, it
may be necessary to increase the cutting height to
reduce the pushing effort and prevent overloading
the motor. For extremely heavy mulching, it is
advisable to first cut at a high cut height setting,
and then re-cut to the final cut height. Otherwise,
14
make narrower cuts and mow slowly.
3) For the best performance, keep the mower
housing free of built-up grass. From time to time
turn off mower and wait for the blades to come
to a complete stop. Remove the batteries and
turn mower on its side. Using an object such as a
stick, wipe out any accumulation of grass around
the blade area. Be careful of the sharp edges of
the blade. Ensure to clean the blade area often
when cutting wet or new grass and every time
after the machine is used.
4) Certain types of grass or grass conditions may
require that an area be mulched a second time
to fully disperse the grass throughout the lawn.
If cutting a second time, it is advisable to cut
perpendicular (across) the first cut pattern. DO
NOT CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN A HILL.
5) Change your cutting pattern from week to week.
This will help prevent matting and graining of the
lawn.
6) Do not mow on a slope that has an angle of
o
greater than 20
.
CUTTING AREA
The cutting area can be affected by several factors,
such as cutting height, lawn humidity, grass length
and density. Besides, starting and stopping the
mower too many times during operation will reduce
the cutting area.
TIPS:
1) It is recommended to mow your lawn more
frequently, walk at normal pace, and not to start/
stop the mower too often during operation.
2) For best performance, please ensure battery pack
is fully charged and always cut off 1/3 or less of
the grass height. It is suggested to install a new
blade before the cutting season begins.
3) Walk slowly when cutting long grass, so as to
have more effective cutting and properly discharge
the clippings.
4) Avoid cutting wet grass, otherwise it will stick
to the underside of the deck and the clippings
cannot be collected or discharged properly.
5) A higher cutting height shall be applied to new or
thick grass and it will extend the battery duration.
Removing/emptying grass collection bag
(See Fig. L1, L2)
WARNING! Always check the discharge shield
has closed the discharge outlet before using.
Never lift the discharge shield or remove the mulching
plug when the lawn mower is being used without
fitted grass collection bag.
