Idiomas disponibles
Idiomas disponibles
COMB TO TRIM BEARD
• Use the guide comb from 1 mm to 3 mm according to the desired measurement. For
a three-day beard, use the 3 mm measurement.
TO TRIM
• Attach the comb guide G to the appliance by pressing until it fits into its position with
the teeth facing downwards.
• Cut the hair moving the appliance in the opposite direction of the natural growth of
the hair.
• Always ensure that the teeth of the comb guide are pointing in the direction in which
the appliance is moving.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Turn the appliance off using the on/off switch. (Fig. 2).
• Unplug the appliance from the mains.
• Clean the appliance.
• Put on the protective cover. (F).
CLEANING
• Disconnect the battery charger from the mains and allow it to cool before
undertaking any cleaning task.
• Dismantle the appliance following these steps:
- The head of the appliance is removable and magnetic. To remove the cutting
head, grasp the two sides of the blades and pull it upwards to remove it. (Fig. 3).
• Use the cleaning brush (L) to remove the hair from inside the appliance and the
blades.
• Clean the equipment with a damp cloth with a few drops of washing-up liquid and
then dry it.
• Do not use solvents or products with an acid or base pH, such as bleach, or
abrasive products, for cleaning the appliance.
• Never submerge the appliance in water or any other liquid or place it under running
water.
