Makita 9032 Manual De Instrucciones página 4

FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting arm inclination
The arm can be pivoted and fixed at any desired angle
within the "A" range according to the operating position
or the figure of the workpiece.
1
► 1. Lock lever 2. Arm
Loosen the lock lever by raising it. Pivot the arm to the
desired position, and secure the lock lever to fix the arm
firmly.
Replacing arm
By replacing the standard-equipped arm by optional
one, 6 mm (1/4") or 13 mm (1/2") width belt can be
used. Remove the arm by loosening the screw that
secures the arm. Insert the arm that fits the belt to be
used, and tighten the screw firmly.
1
► 1. Screw 2. Arm
2
"A" range
2
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
► 1. Lock button 2. Switch trigger
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial
► 1. Speed adjusting dial
The belt speed can be infinitely adjusted between 5 m
and 28 m per second (980 - 5600 ft./min.) by turning
the speed adjusting dial to a given number setting from
1 to 6.
Higher speed is obtained when the dial is turned in the
direction of number 6; lower speed is obtained when it
is turned in the direction of number 1. Select the proper
speed for the workpiece to be sanded.
CAUTION:
• The speed adjusting dial can be turned only as
far as 6 and back to 1. Do not force it past 6 or
1, or the speed adjusting function may no longer
work.
4 ENGLISH
1
2
1