Makita PC5000C Manual De Instrucciones página 6

Level planing (for PC5001C only)
3
► 1. Base (for PC5001C only) 2. Hex wrench 3. Front
roller
To level a surface, the base of the planer should be
aligned with the diamond wheel. The front roller should
be adjusted (use hex wrench) upward to the level
required for the desired stock removal amount.
To change the amount of stock (concrete) removed,
loosen the hex socket head bolts on the base holder
with the hex wrench. Raise or lower the front roller to
adjust the gap between it and the diamond wheel. The
difference is the stock removal amount. Then secure
the hex socket head bolts very carefully.
1
2
► 1. Hex socket head bolt 2. Stock removal amount
NOTE:
• Maximum stock removal should be less than 4.0
mm (5/32").
Tilting base for smoother planing
(for PC5001C only)
For smooth removal of a given surface roughness or
texture, tilting the base is helpful. Use the hex wrench to
loosen the two hex socket head bolts securing the base
on either side.
1
2
2
► 1. Base 2. Hex wrench 3. Hex socket head bolt
Use a hex wrench to lower the three hex socket
head bolts on the base by turning them on the base
clockwise.
► 1. Hex wrench 2. Hex socket head bolt
Use a square or ruler to obtain the desired base angle
in relation to the diamond wheel. Then secure carefully
the hex socket head bolts on either side of the base.
Adjust center of base near wheel so that it is on the
same level as the wheel.
1
► 1. Same level 2. Square or ruler 3. Hex socket head
bolt
6 ENGLISH
3
1
1
2
2
Max.
6
3