Idiomas disponibles
Idiomas disponibles
• Please note that ice splinters can form and block the ice
cube slide. In this case, after switching on, the mecha-
nism is moved back and forth until it is free again.
- If you want to remove the ice splinters yourself, first
pull the mains plug out of the socket.
• Note the waiting time of at least 3 minutes if you want to
continue the operation.
• You can change the size of the ice cubes as long as the
compressor is switched off.
ICE FULL Control Lamp (Ice Cube Container Full)
As soon as the ice cube container is full, production stops.
The ICE FULL control lamp lights up. The compressor
switches off.
1. Remove the ice cubes. If necessary, use the enclosed
ice scoop. When removing the ice cube container, some
water drips through the holes at the bottom.
2. After the ICE FULL control lamp goes out, ice cube pro-
duction starts again automatically after a while.
WARNING:
• Switch off the appliance before maintenance and cleaning. Pull
the mains plug out of the socket.
• Never immerse the appliance in water for cleaning. It could
cause an electric shock or fire.
CAUTION:
• Do not use a wire brush or other abrasive objects.
• Do not use harsh or abrasive cleaners.
• Do not use chemicals, acids, petrol or oil.
Cleaning Programme
With this programme, the water system is rinsed several
times. The process takes about 5 minutes.
Important! The appliance should not be disconnected from
the mains during the cleaning programme.
1. There is an arrow in the water tank below the MAX mark.
Fill approx. 1 litre of fresh water into the water tank, up to
a maximum of below the arrow.
2. While the appliance is in standby mode, press and hold
the
button for about 2 seconds. The appliance starts
EWB3798_IM
Cleaning and Maintenance
ADD WATER Control Lamp (Water Shortage)
The control lamp indicates when there is not enough water
in the water tank. Ice cube production is automatically
interrupted.
1. Open the lid.
2. Empty the ice cube container.
3. Refill with drinking water as described in "Making Ice
Cubes". As there may still be residual water in the appli-
ance, observe the MAX marking in the water tank.
4. Reinsert the ice cube container and close the lid.
5. Press the
button. The ADD WATER control lamp goes
out. The appliance is in standby mode again. You can
continue with the operation.
Ending Operation
1. Press the
button to stop ice cube production. The
control lamp SMALL flashes.
2. Unplug the mains plug from the socket.
3. Remove the ice cube container.
4. Drain the remaining water as described in "Cleaning and
Maintenance".
5. Leave the lid of the appliance open so that no fungal
cultures or bacteria can form.
the cleaning programme. The four control lamps flash
alternately.
3. The appliance automatically switches to standby mode
when the cleaning programme is finished.
4. Drain the water from the appliance. Dispose of the water.
Draining Residual Water
Drain the residual water after each use of the appliance or
at the end of the day.
1. Place the appliance on the edge of a table. Hold a bowl
under the water drain opening.
2. Pull out the plug at the bottom.
3. After the residual water has drained off, put the plug back
in the opening.
11
05.07.23
