Makita DUR141 Manual De Instrucciones página 11

To remove the Nylon cutting head (spool and spool
cover) from the string trimmer, press in the latches
forcefully on both sides of the spool cover and raise it.
1
2
► 1 . Nylon cord eyehole 2. Notch of the nylon cutting
head installation port 3. Spring 4. Spool holder
NOTICE:
• Make sure that the spring is installed inside the
spool holder.
To install a cord-newly-wound Nylon cutting head (spool
and spool cover) on the string trimmer, align the Nylon
cord eyehole with the notch of the Nylon cutting head
installation port on the trimmer and then press in it until
a click is heard.
Winding a new Nylon cord on the
spool
Remove the spool from the spool cover and take off the
remaining used Nylon cord from the spool.
1
► 1 . Nylon cord 2. Retainer for nylon cord end
Insert a Nylon cord to the retainer shown in the figure.
3
4
Wind it tightly flat around the spool in the direction of
arrow on the spool so that the wound Nylon cord sur-
face appears uniform over the winding area.
11 ENGLISH
2