Idiomas disponibles
Idiomas disponibles
Before using the appliance
•
Check the following:
•
Make sure the voltage of the hot air gun corresponds with the power voltage;
•
Are the mains lead and the mains plug in a good state: strong, untangled and undamaged?
•
Avoid the use of long extension cables;
•
Do not use the appliance under moist circumstances;
•
The metal mouthpiece gets hot. Watch out and do not touch the metal mouthpiece;
•
Prevent damage of the heating element. Do not lock or block the mouth piece;
•
Do not leave the appliance when switched on;
•
Do not use the appliance for drying hair or for drying living human beings in general;
•
Do not use the appliance in a bath, above water or in spaces where easy inflammable
liquids are used.
This appliance operates at a temperature of 600 degrees without visible signs of
this temperature (no flames), but there is nonetheless a chance of fire risk.
Watch out for the hot air stream from the mouth piece. This air stream can
cause burns.
When operating the appliance
•
If you are going to use the hot air gun, vapours and gas may be released for short periods.
This can be harmful for your health. Asthmatics may suffer hindrance from it;
•
Before connecting the plug to the mains voltage you must check whether the switch is in the
"0" position;
•
Keep the mains lead away from the mouthpiece of the hot air gun at all times;
•
Keep children and animals away from the appliance if you are using it.
Immediately switch off the appliance when:
•
The plug and/or cable are defective or damaged;
•
The switch is defective;
•
You smell or see smoke caused by scorched insulation from the hot air gun.
Electrical safety
When using electric machines always observe the safety regulations applicable in your country
to reduce the risk of fire, electric shock and personal injury. Read the following safety instruc-
tions and also the enclosed safety instructions.
Always check that the power supply corresponds to the voltage on the rating plate.
Class II machine – Double insulation – No earthed plug is required
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet. If the supply cord is damaged, it
must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The mini-
mum conductor size is 1.5 mm2. When using a cable reel always unwind the reel completely.
14
