Idiomas disponibles
Idiomas disponibles
Congratulations,
We thank you for choosing a Mixy Link dosing pump. With the Mixy Link, you will be able to enjoy your pool
without worrying about water disinfection. For any additional question relating to the use of this product, please
contact your dealer.
1.0 INTRODUCTION
The purpose of the Installation and User Manual for the Mixy Link dosing pump is to provide you with
all the information necessary for a proper installation, use and maintenance. For safety reasons, it is
essential to read this document carefully and store it in a safe and
clearly identified place, for
subsequent use.
SAFETY MEASURES
1.1
Always use appropriate safety gear (goggles, mask, gloves, suitable clothing) when operating the dosing
pump (operation, maintenance, service) in order to avoid any risk of injury by ejection or leak of the
injected liquid that may be in the body of the pump.
Please refer to the Security sheet of the chemical product, provided by the supplier.
1.2 PACKAGE COMPRISES
1 factory-wired pump body (with 3m cable)
1 factory-wired display panel with one 2 pole plug 230V (with 1.5m cable)
2 buffer solutions pH4 and pH7 (pH pump only)
1 buffer solution 468 mV (Redox pump only)
1 pH probe or 1 Redox with 5 m cable
1 Probe holder ½"
1 injection nozzle ½"
1 foot valve
2 m of crystal-clear flexible PVC tubing
2m of rigid PVC tubing
2 wall hangers + screws + pins
2 mounting claps diam 50-½"
1 drilling template
1 instruction manual
WARNING
Any intervention on this material must be done by skilled personnel.
Prevent access to the pump room to non competent people.
Keep the children away from the pump room.
In case of anormal operation, disconnect the dosing pump and contact a professional.
The whole electrical installation must be done in conformity to local running standards (NF C 15-100 in France),
check that the electric data mentioned on the label stuck on the pump are compatible with the mains.
Protection by a ground fault 30 mA is compulsory.
Do not set the probe as long as water is not correctly filtered, in order to avoid any early alteration.
Ambient temperature during operation should never excess 40°C. Minimum temperature depends on the fluid to
be injected, that is always to stay at a liquid state.
It is compulsory to use liquid chemical products in order to avoid any risk of crystallization.
The use of other chemical products than the ones that are recommended and specifically devoted to swimming
pools is hazardous. Follow the instructions provided by the chemical products suppliers, and identify clearly the
chemical solution tanks.
1.3 WEAR AND TEAR PARTS
The peristaltic pipe is considered as a wear and tear part, as it is subjected to daily alteration and must be
replaced at least once a year.
The measure probe is considered as a wear and tear part (cf guarantee), being subjected to a natural ageing
depending on its use.
Release any electro-statics and handle the probe with care, hold it by its plastic cap or by the pipe, but do not
touch the measuring head .
100897- indB – 0209
15 / 40
