Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS (CONTINUED)
12. If igniter does not light burner:
:
a. Wearing heat-resistant gloves, position a long lit match or long lit butane lighter near the pilot housing.
.
b. Push and turn control knob to "ON ".
c. Remove match/lighter once burner is lit.
CAUTION: After lighting - using a firepit tool and heat - resistant gloves, carefully move the glass beads back to
their proper position, being careful to avoid the flame.
13. After lighting, observe the burner flame make sure all burner ports are lit and flame height matches illustration (Figure 7) .
CAUTION: If ignition does not occur in 5 seconds, turn control knob to
newspaper or magazine and repeat lighting procedure.
Turning Off
1. Turn LP gas tank valve to " CLOSED".
2. Turn control knob to the "
3. Disconnect LP gas tank per "Disconnecting LP Gas Tank" section.
CLEANING AND CARE
CAUTION:
1. All cleaning and maintenance should be done when outdoor firepit is cool and with the fuel supply disconnected.
2. Do not clean any outdoor firepit part in a self-cleani ng oven, the extreme heat will damage the finish.
3. Do not enlarge valve orifices or burner ports when cleaning the valves or burners.
Notices
1. This outdoor firepit should be thoroughly cleaned a nd inspected on a regular basis.
2. Abrasive cleaners will damage this product.
. 3
N
E
V
E
R
u
s
e
o
v
e
n
Before Each Use:
1. Keep the outdoor firepit area clear and free from any combustible materials, gasoline and other flammable vapors
and liquids.
2. Do not obstruct the flow of the combustion of LP gas and the ventilation of air.
3. Keep the ventilation opening(s) of the LP gas tank area free and clear from debris.
4. Visually check the burner flames to make sure your outdoor firepit is working properly (Figure 7).
5. See below for proper cleaning instructions.
6. Check all gas connections for leaks.
7. Check components for any signs of damage or rust.
8. Check for obstructions of airflow to the burner. Spiders, insects and webs can clog the burner/venturi tube. A clogged
burner/venturi tube can lead to a fire.
9. If damage to any component is detected, DO N OT operate until repairs are completed.
Cleaning Surfaces
1. Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with wat.
2. For stubborn stains, use a citrus-based cleaner and a nylon scrubbing brush.
3. Rinse clean with water.
4. Allow to air dry.
Before Storing
1. Turn LP gas tank valve to "CLOSED".
2. Turn control knob to the "
3. Disconnect LP gas tank per "Disconnecting LP Gas Tank" section.
4. Clean all surfaces.
5. Lightly coat the burner with cooking oil to prevent excess rusting.
CAUTION: NEVER place cover on hot outdoor firepit.
6. If storing the outdoor firepit indoors, cover and store in a cool dry location away from children
and pets.
7. If storing the outdoor firepit outdoors, cover with the included cover for protection from the weather.
.
OFF" position. Note: A "poof" sound is normal as the last of the LP gas is burned.
c
e l
a
n
r e
o t
c
e l
a
n
a
n
y
p
a
t r
f o
OFF" position. Note: A "poof" sound is normal as the last of the gas is burned.
"
h t
s i
o
u
d t
o
r o
firepit .
13
wait 5 minutes, fan with a
OFF
" ,
