Hilti SF 14-A Manual De Instrucciones página 16

to these chemicals, the operator and bystanders should work in a
well-ventilated area, work with approved safety equipment, such as
respiratory protection appropriate for the type of dust generated,
and designed to filter out microscopic particles and direct dust
away from the face and body. Avoid prolonged contact with dust.
Wear protective clothing and wash exposed areas with soap and
en
water. Allowing dust to get into your mouth, eyes, or to remain on your
skin may promote absorption of harmful chemicals.
5.3.2 Electric tool use and care
a) Secure the workpiece. Use clamps or a vice to secure the work-
piece. The workpiece is thus held more securely than by hand and both
hands remain free to operate the power tool.
b) Check that the insert tools used are compatible with the chuck
system and that they are secured in the chuck correctly.
c) Large and heavy insert tools must only be operated in first gear.
There is otherwise a risk that the tool will be damaged when it is switched
off or, under unfavorable conditions, the chuck might be detached.
5.3.3 Battery tool use and care
a) Ensure the switch is in the off position before inserting battery pack.
Inserting the battery pack into power tools that have the switch on invites
accidents.
b) Do not expose batteries to high temperatures or fire. This presents
a risk of explosion.
c) Do not disassemble, squash or incinerate batteries and do not sub-
ject them to temperatures over 80°C (176°F). A risk of fire, explosion
or injury through contact with caustic substances may otherwise result.
d) Avoid ingress of dampness.Dampness may cause a short circuit
resulting in a risk of burning injury or fire.
e) Do not use batteries other than those approved for use with the
applicable power tool or appliance. Use of other batteries or use of
the battery for purposes for which it is not intended presents a risk of
fire and explosion.
Observe the special instructions applicable to the transport, storage
f)
and use of Li-ion batteries.
g) Avoid short-circuiting the battery. Check that the terminals on the
battery and in the power tool are free from foreign objects before
inserting the battery in the power tool. Short circuiting the battery
terminals presents a risk of fire, explosion and chemical burns.
12
Printed: 30.09.2013 | Doc-Nr: PUB / 5071630 / 000 / 02
All manuals and user guides at all-guides.com