Hansgrohe 31741180 Instrucciones De Montaje página 4

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal pressures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The fittings must be mounted in an insulated manner
and with sound insulation.
Assembly (see page 33)
• Install body with G 3/4 outlet pointing downwards.
• Depth of fitting: 68 mm to 96 mm.
• extension set 28 mm
Note: When installation is complete ensure
that the mixer is turned off!
A Direct wall installation.
B Direct wall installation with 10 mm adjustable
mounting studs.
C Brick wall installation.
Technical Data
Operating pressure:
Recommended operating pressure:
4
English
max. 1 MPa
0,1 - 0,5 MPa
Assembly (see page 33)
Test pressure:
Hot water temperature:
Thermal disinfection:
Connections Rp 1/2:
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 34)
To adjust the hot water limiter. Using a hot water limiter in
combination with a continuous flow water heater is not
recommended.
Dimensions (see page 35)
Flow diagram (see page 35)
free flow

Tub outlet

Shower outlet
Spare parts (see page 37)
Special accessories (see page 37)
order as an extra
• extension set 28 mm #32498000
Final assembly (see page 36)
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 60°C
70°C / 4 min
cold right - hot left