Idiomas disponibles
Idiomas disponibles
Battery installation (A)
Insert the batteries observing the positive(+) and
negative(-) polarities as per illustration A .
Service life of batteries
The batteries normally last for about one year
despite that it depends on how often and in
what way the remote control is operated.
If the remote control fails to work even when
operated near the DVB receiver, replace the
batteries.
Use size 7 (AAA, UM-4) batteries (2 pieces).
Notes:
Do not use rechargeable (Ni-Cd) batteries.
Do not attempt to recharge, short circuit,
disassemble, heat the batteries or throw them
into the fire.
Do not drop, tramp or impact the remote control.
This may damage the parts and lead to
malfunction.
Do not mix used battery with new one ever
when using.
If the remote control shall be spared for a long
time, remove the batteries. Otherwise,
electrolyte may leak, which may lead to
malfunction, even fire accident when some
substance contacts with the electrolyte.
Wipe away the electrolyte having leaked inside
the remote control, and replace with new
batteries.
If any electrolyte happens to touch some parts
of your skin, wash it off thoroughly with clean
water immediately.
Operation range of remote control (B)
Pointing the remote control to the signal sensor,
it shall be effective to operate the remote
control within a distance of about 5 meters
and an angle of about 60 degrees. (See
illustration B)
The effective range may vary slightly with the
brightness of the room.
Note:
Do not point bright light to the remote control
sensor.
Make sure that there is not any shield between
the remote control unit and the sensor when
use it.
Do not use this remote control and remote
controls of other equipments simultaneously.
Bmt-76.p65
Remote control preparation
-31-
31
06-4-10, 19:33
