Idiomas disponibles
Idiomas disponibles
Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy bottom cover (D) from the canopy (C) by
turning the bottom cover counterclockwise until it unlocks.
□
Loosen the two canopy screws (FF) located in the bottom of the
mounting bracket (A), and turn the canopy counterclockwise to
remove the mounting bracket (A) from the canopy (C).
A
FF
C
D
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the set screws (ZZ) on the collar on
top of the motor housing (F).
□
Align the holes at the bottom of the downrod (B) with the holes in
the collar on top of the motor housing (F).
□
Carefully insert the hanger pin (BB) through the holes in the
collar and downrod (B). Be careful not to jam the hanger pin (BB)
against the wiring inside the downrod (B).
□
Insert the locking pin (CC) through the hole near the end of the
hanger pin (BB) until it snaps into its locked position.
□
Re-tighten the two set screws (ZZ) on the collar on top of the
motor housing.
2
Routing the wires
□
Route the wires exiting the top of the fan motor (F), through
the coupler cover (E) and canopy bottom cover (D).
□
Make sure the slot openings are on top and route the wires
through the canopy (C) and then through the ball downrod
assembly (B).
B
C
D
E
F
BB
7
Please contact 1-855-HD-HAMPTON for further assistance.
CC
ZZ
HAMPTONBAY.COM
