Idiomas disponibles
Idiomas disponibles
TIP
9.2.4. Battery Error Description
LED In-
Error
dicator
No.
Yellow
Error 01
LEDs
on or
Yellow
Error 05
LEDs
flash
Error 06
once per
second
Error 08
Error 09
Error 10
Error 11
Error 12
Error 13
Error 14
Error 15
TIP
© 2023 Maxeon Solar Technologies, Ltd. All rights reserved. | 547143 Revision B - June 2023
Specifications included in this document are subject to change without notice
In the case of work mode, if the protection status "Cell under voltage"
appears, please press the power button 5 times within 10 seconds, the
BMS will be forced to turn on the MOSFET of discharge so that the inverter
can detect the battery open voltage and charge the battery.
LED Display
Description
Hardware error
Hardware error
Circuit breaker
open
LMU disconnect
(slave)
SN missing
LMU disconnect
(master)
Software
version
inconsistent
Multi master
MOS over
temperature
Insulation fault
Total voltage
fault
In the case of work mode, if the protection status "Cell under voltage"
appears, please press the power button 5 times within 10 seconds, the
BMS will be forced to turn on the MOSFET of discharge so that the inverter
can detect the battery open voltage and charge the battery.
Troubleshooting
Wait for automatic recovery.
If the problem is not solved yet,
please call Error 05 Hardware error
the service center.
Switch on circuit breaker after
powering off the battery.
Reconnect the BMS communication
cable.
Contact your installer or customer
service.
Reconnect the BMS communication
cable.
Contact your installer or customer
service.
Restart all batteries.
Power off the battery and power on
the battery after 30 minutes.
Restart battery and in case the
problem is not resolved, please
contact your installer
Restart battery and in case the
problem is not resolved, please
contact your installer or customer
service.
60
