Comfort Functions - MAXA 3500 W Manual Usuario/Instalador

• Adjust fan speed by pressing FAN SPEED key (3), choosing between AUTO and other speeds HIGH-MED-LOW;
• Point the remote control at the unit receiver and press the ON/OFF key ON/OFF (4);
• Adjust the airflow in keeping with requirements by using the SWING key (5) or AIR DIRECTION key (6). Once these
adjustments have been made, they will be offered when the unit is switched back on. If received by the unit, every
signal transmitted by the remote control is confirmed by a "beep".
1. 5.5 Fan mode
To set the fan mode FAN, proceed as follows:
• Select the fan mode by pressing the MODE key (1);
• Adjust fan speed by pressing FAN SPEED key (3), choosing between AUTO and other speeds HIGH-MED-LOW;
• Point the remote control at the unit receiver and press the ON/OFF key ON/OFF (4);
• Adjust the air flow in keeping with requirements by using the SWING key (5) or AIR DIRECTION key (6); once these
adjustments have been made, they will be offered when the unit is switched back on. If received by the unit, every
signal transmitted by the remote control is confirmed by a "beep" sound.

1. 5.6 Comfort functions

1. 5.6.1 Anti-Heating
The ANTI-HEATING function is envisaged for COOL and DRY operating modes. It prevents the fan from starting up if
the inlet water temperature at the exchanger is above 22°C for the minimum speed and 25°C for the medium and
maximum speed, thus preventing unpleasant hot air flows. This situation could occur the first time the unit is started or
after long periods out of use. When the ANTI-HEATING function is active, the red DEF./FAN LED is on.
1. 5.6.2 Anti-Cooling
The ANTI-COOLING function is envisaged for the HEAT operating mode. It prevents the fan from starting up if the inlet
water temperature at the exchanger is below 28°C for the minimum speed and 32°C for the medium speed and
maximum speed, thus preventing unpleasant cold air flows. This situation could occur the first time the unit is started or
after long periods out of use. When the ANTI-COOLING function is active, the red DEF./FAN LED is on.
IMPORTANT!
The unit fan stops when the set temperature is reached and is then automatically reactivated at minimum
speed to prevent air stratification phenomena in the vicinity of the appliance.
45